1ԺԺȴ򿪵ļԭĸطһ㶼½ǡ ͵ԻԭҲ½ǡ
2λ½ǵĵطȻµµʱһҪᣩԺСЩʹӴɡ
3Ҫ) µԺXY㡱͡Z㡱ȻͿԵʼťʼˡ

ȿһϤһ


1, After adjusting the machine, open the engraving file to check where the zero point is, usually at the lower left corner, the same as the 2 test codes.
2, Locate the machine to the lower left corner of the workpiece first, then lower the cutter and the spindle must be turned on. Slow it down when the cutter is close to the workpiece, gently adjust it to the surface. 
3, Important! After lowering the cutter, click "XY zero " and "Z zero". Then you can click "start" to engrave. 

Tips: It is better to run the machine without any workpiece first. Test it before you start formal engraving. 

https://www.youtube.com/watch?v=2cTWorAPfDU&feature=youtu.be  First of all, please watch this video carefully